Pinewood Derby Car Decals

1. The design is printed on a "carrier sheet". The sticky back is covered by a "tissue backing". Do not separate these two sheets.

2. Cut out the design that you want. Cut through both sheets.

3. Remove the tissue backing from that design only. Set the tissue backing aside. You will need it later.

4. Place your design face up on the car surface. Do this carefully as the design will stick wherever you place it.

5. Smooth it down with your finger starting at one edge.

6. Use a blunt pencil or similar object and rub down the design.  Rub all of the design with moderate pressure until it starts to separate from the carrier.

7. Lift one corner of the carrier sheet slightly with your fingers but not enough to lift any part of the actual decal away from the car. Rub the part of the decal closest to the raised edge just enough to transfer it to the car surface.  Keep lifting the carrier sheet as you rub, paying special attention to the edges of the design as you go.  If you miss transferring a piece of the design, reposition the carrier sheet over the design and complete the transfer.

8. Use the tissue backing to gently rub the design to smooth it on the surface.

9. Completed decal