Pinewood Derby Car Display Stand Assembly Instructions
- Align hole in metal bracket with the indentation on top
of base.
- With a hammer, gently tap brass bracket pin through hole
in bracket into oak base.
|
- Mark two x's 4 1/2" apart on the bottom of your Pinewood
Derby Car. Screw mounting screws 3/4" of the way into
the bottom of the car at the x's.
- Press ends of mounting bracket inward, slip under mounting
screws on bottom of car and release. If bracket is too narrow,
spread ends to fit.
- Tighten the mounting screws.
|
The parts on this derby car stand
are finished and it is ready to use after assembly.
If desired,
you can mount an engraved nameplate on the sloping front of
the base. |
|
view
shopping cart 
product
catalog
